HPLC-UV comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2026-02-13. Numbers and descriptions here follow the published literature rather than marketing material.
Quality assessment of creatine monohydrate typically uses high-performance liquid chromatography to separate creatine from creatinine and other impurities. Other methods include nuclear magnetic resonance spectroscopy, titration, and infrared spectroscopy for identity confirmation. Purity is often reported as a percentage of the labeled compound on a dry basis, while moisture content is measured separately. Because different analytical methods have different selectivity, comparing purity values across sources requires attention to the method and sample preparation.
In dry solid form, creatine monohydrate is relatively stable when protected from moisture and heat. The crystal lattice includes water, and exposure to high humidity can cause caking or gradual changes in powder flow. Elevated temperatures may accelerate decomposition, particularly if moisture is present. Studies generally report that sealed, dry material retains acceptable purity for extended periods, although exact shelf life depends on packaging and storage conditions. Light exposure is not usually considered a major factor for this compound.
In aqueous solution, creatine monohydrate undergoes a slow conversion to creatinine, a cyclized degradation product. This reaction is pH- and temperature-dependent, and it proceeds faster in warm or alkaline conditions. Because the conversion is gradual, analytical measurements of creatine in solution must account for time and storage history. The equilibrium favors creatinine more strongly at higher temperatures, which is relevant to sample handling in laboratories and to beverage formulations. Refrigeration slows but does not entirely stop this process.
Analytical methods for creatine monohydrate focus on identity, purity, and degradation products. High-performance liquid chromatography with ultraviolet detection is common, often at a wavelength near 210 nanometers. Titration and nuclear magnetic resonance spectroscopy can also quantify the parent compound. Pharmacopeial monographs specify tests for appearance, solubility, water content, and related substances, including creatinine. Purity values above 99 percent are typical for pharmaceutical-grade material, though supplement-grade products vary. Independent verification can detect label discrepancies.
Sourcing and verification of creatine monohydrate involve both manufacturing origin and third-party testing. Industrial production commonly starts with sarcosine and cyanamide, followed by crystallization to obtain the monohydrate. Some products are derived from animal sources, while others are synthesized from non-animal precursors. Certificates of analysis report assay, heavy metals, and microbial limits. Regulations differ by country: in the United States it is sold as a dietary supplement, whereas in the European Union it falls under food supplement rules.
In solid form, creatine monohydrate is relatively stable when kept dry and away from heat. Moisture and elevated temperatures promote cyclization into creatinine, a related compound with no role in the phosphagen system. Degradation accelerates in aqueous solution, where the conversion can occur within hours to days depending on pH and temperature. Manufacturers typically recommend storage in sealed containers at room temperature, with relative humidity below 50 percent. Long-term stability data for opened containers are limited.
| Property | Value | Notes |
|---|---|---|
| Typical storage temperature | 15–25 °C | Cool, dry, sealed container; avoid heat |
| Relative humidity | Low; keep below about 60% | Moisture promotes caking and degradation |
| Primary degradation product | Creatinine | Forms by cyclization, especially in solution |
| Common assay method | HPLC with UV or RI detection | Separates creatine from creatinine and related impurities |
| Moisture content | Typically reported as percentage | Measured by Karl Fischer titration or loss on drying |
Commercial creatine monohydrate is typically manufactured through chemical synthesis, often starting from sarcosine and cyanamide. The resulting material is crystallized, washed, and dried to a specified hydrate content. Finished lots are tested for identity, purity, moisture, and heavy metals before release. Because the compound can cyclize to creatinine under heat or prolonged storage in solution, manufacturers control temperature and humidity during processing. The solid itself is relatively stable when kept dry and sealed, but moisture uptake can cause caking and complicate accurate assay.
Analytical laboratories commonly identify creatine monohydrate by high-performance liquid chromatography with ultraviolet detection, often after dissolving the sample in water or dilute acid. Ion-exchange or reversed-phase columns separate creatine from creatinine and related guanidino compounds. Nitrogen content can be checked by Kjeldahl or combustion methods, while moisture is measured by Karl Fischer titration or loss on drying. These techniques give complementary views: chromatographic purity addresses related substances, whereas moisture and elemental data confirm hydrate stoichiometry. No single test defines quality by itself; a combination is used in specifications.
=== Sources === Calvin, Melvin (1969). Chemical Evolution: Molecular Evolution Towards the Origin of Living Systems on the Earth and Elsewhere. Oxford, UK: Clarendon Press. ISBN 978-0-19-855342-7. LCCN 70415289. OCLC 25220. Lane, Nick (2023) [2022]. Transformer: The Deep Chemistry of Life and Death. Profile Books. ISBN 978-1-7881-6055-1.
Eugenic philosophy claimed scientific legitimacy to uphold racial stereotypes of latino/as, deeming them as unfit and even "hyper-fertile, inadequate mothers, criminally inclined, and more prone to feeblemindedness." At a time of segregation and growing anti-Mexican immigration sentiment, eugenic programs have been linked to efforts to reduce immigration. The laws in California from 1909 to 1979 allowed for nonconsensual sterilization of over 20,000 individuals. The forced sterilizations in California began in 1909 when a eugenics law was passed. It allowed doctors to sterilize people who were thought to be "unfit" to have children at state hospitals. Before this law was nullified in 1979, more than 20,000 people, including teenagers were victims of this sterilization. Doctors recommended people who they thought should be sterilized for certain reasons; this included not only people with a medical condition but also perfectly healthy ones as well. Minors as young as thirteen years old were sterilized. This law was meant to keep the "undesirable population" from growing. Women of Latina Origin were 59% more likely to be sterilized than women who were not of latino descent. An example of California's eugenic and neo-eugenic practices is a case from 1966. Nancy Hernandez was a 21-year-old mother of two in Santa Barbara, California. Nancy pleaded guilty, in 1966, for being with her boyfriend, Joseph Sanchez, while he used illegal narcotics.
Chromatin immunoprecipitation (ChIP) is a method used to determine the location of DNA binding sites on the genome for a particular protein of interest. This technique gives a picture of the protein–DNA interactions that occur inside the nucleus of living cells or tissues. The in vivo nature of this method is in contrast to other approaches traditionally employed to answer the same questions. The principle underpinning this assay is that DNA-binding proteins (including transcription factors and histones) in living cells can be cross-linked to the DNA that they are binding. By using an antibody that is specific to a putative DNA binding protein, one can immunoprecipitate the protein–DNA complex out of cellular lysates. The crosslinking is often accomplished by applying formaldehyde to the cells (or tissue), although it is sometimes advantageous to use a more defined and consistent crosslinker such as dimethyl 3,3′-dithiobispropionimidate-2 HCl (DTBP). Following crosslinking, the cells are lysed and the DNA is broken into pieces 0.2–1.0 kb in length by sonication. At this point the immunoprecipitation is performed resulting in the purification of protein–DNA complexes. The purified protein–DNA complexes are then heated to reverse the formaldehyde cross-linking of the protein and DNA complexes, allowing the DNA to be separated from the proteins. The identity and quantity of the DNA fragments isolated can then be determined by polymerase chain reaction (PCR).
=== NNR === Research overview: This study involves creating a combination of model membranes which contain 1,2-dipalmitoyl-sn-glycero-3-phosphocholine (DPPC) and 1,2-distearoly-sn-glycero-3-phosphocholine (DSPC) referred to as the "host membranes", phospholipids labeled as 1,2,& 3 referred to as "exchanging molecules" or "reporting molecules" and varied cholesterol mole percentages in the presence of an aqueous solution containing 5% ethanol (v/v). The host membranes were chosen because their phase diagrams are well understood and have been extensively characterized by different analytical techniques.6 The nearest neighbor recognition technique is being applied to the formation of the modeled membranes to observe the association between cholesterol and phospholipids as well as the effects that the presence of ethanol has against this interaction. Researchers are observing whether or not ethanol enhances or disrupts the liquid-ordered phase by reorganizing this formation into a liquid-disordered phase. The liquid-ordered phase is similar to a lamellar phase and the liquid-disordered phase represents the non-lamellar phases but the exact type of each phase (hexagonal, cubic, etc.) is not described. As previously mentioned several different combinations of the host membranes, exchanging molecules, and cholesterol are created to form the model membranes. It is important to mention that the exchanging molecules selected have similar properties to the host membranes.
Sources: en.wikipedia.org
'High-throughput quantitative bioanalysis by LC/MS/MS', Volume 14, Issue 6, Oct 2000, Pages: 422 - 429, Jemal M. Cited 178 times 'Analytical Chemistry and Biochemistry of D-Amino Acids', Volume 10, Issue 6, Nov-Dec 1996, Pages: 303–312, Imai K, Fukushima T, Santa T, et al. Cited 79 times 'Fluorogenic and fluorescent labeling reagents with a benzofurazan skeleton', Volume 15, Issue 5, Aug 2001, Pages: 295–318, Uchiyama S, Santa T, Okiyama N, et al. Cited 74 times
Originally planned for the second revolution, the astronauts postponed the EVA until the third after McDivitt decided that White, following the stress of the launch and the failed rendezvous, looked tired and hot. After a rest, the pair finished performing the checklist for the EVA. Flying over Carnarvon, Australia, they began to depressurize the cabin. Over Hawaii, White pulled the handle to open his hatch, but the latches failed to move. Fortunately, McDivitt knew what the problem was, because the hatch had failed to close in a vacuum chamber test on the ground, after which McDivitt worked with a technician to see what the cause was. A spring, which forced gears to engage in the mechanism, had failed to compress, and McDivitt got to see how the mechanism worked. In flight, he was able to help White get it open and thought that he could get it to latch again. There were communication problems during the spacewalk. Gemini spacecraft were the first to use a voice-operated switch (known as VOX) on the astronaut's microphones, but McDivitt soon realized that his VOX circuit was not working properly; he could only hear the Capsule Communicator (CAPCOM) in the push-to-talk setting, but not on VOX (though both astronauts could be heard by each other and the ground). Plus, while outside the spacecraft, White was unable to receive transmissions from the ground and had to have all messages relayed through McDivitt.
== History == 4-HO-MET was first synthesized and discovered by Alexander Shulgin in the 1970s. It was first described in the scientific literature by David Repke and colleagues by 1981. Subsequently, 4-HO-MET was described by Shulgin in his book TiHKAL (Tryptamines I Have Known and Loved) in 1997 as being- aside from its synthesis- indistinguishable from any other ethyl homologue. It was encountered as a novel recreational and designer drug in Europe by 2008 and recently in the United States in 2025.
Sources: en.wikipedia.org
Dry, sealed creatine monohydrate can remain stable for years, but storage conditions affect its shelf life. Moisture, heat, and repeated opening of containers can reduce quality over time.
Creatine can lose a water molecule and cyclize into creatinine, especially in aqueous solution and at elevated temperatures. This is a chemical degradation process rather than microbial spoilage.
High-performance liquid chromatography is commonly used to quantify creatine and detect creatinine. Identity can be confirmed with spectroscopy or other instrumental methods.
Yes, especially when exposed to moisture or heat, where it converts to creatinine. In dry, sealed containers at room temperature, degradation is slow and the product may remain within specification for two to three years.